And also, I like to monitor the hard disk status without stopping the machine, it hosts some web sites.
#MEGACLI CHECK DISK HEALTH HOW TO#
Products Solutions Support and Services Company How To Buy Support Portal.
#MEGACLI CHECK DISK HEALTH INSTALL#
But you can also install megaraid-manager, and/or command-line tools (storcli/megacli). Read the accessibility statement or contact us with accessibility-related questions. We look for its presence in the system: lspci grep RAID Example Result: 01:00. I can configure the raid array (MegaRaid Menu), see the status well on BIOS, but the thing is I put my machine in a data center, so, can not see BIOS screen. No other software is needed if all you need is to check health-status. Introduction: This HowTo show how to check the health of Hard Disks connected to a ‘LSI Logic/Symbios Logic MegaRAID SAS 2108’ RAID controller. I tried megacli tool, every commands I type just return "Exit Code: 0x00" Device Id: 4 - First Device Device Id: 5 - Second Device. The Device IDs are in order of what cable there plugged into on the Raid Card. Memory at fb4f8000 (32-bit, non-prefetchable) Ĭapabilities: MSI: Enable+ Count=1/1 Maskable- 64bit-Ĭapabilities: Power Management version 3įrom your comments, I believe mine is fakeraid. To Test SAS Disks you need to run the following commands: The command below will give you all the device Ids for each drive on the raid card. When using Software RAID then the command is very simple, eg: smartctl -a /dev/sda. For example, for Symbios/LSI/Avago MegaRAIDs and recent Dell PERCs: smartctl -i /dev/sda -d megaraid,0 smartctl 6.6 r4324 x8664-linux-4.15.18-1-pve (local build) Copyright (C) 2002-16, Bruce Allen, Christian. And of course, sometimes we need to know important information about our disks, let say disk health status. In general, you smartctl from smartmontools is able to see hard disk info through various hardware RAID controllers. I have several boxes using RAID controller from LSI brands.
Test with the following command: /opt/MegaRAID/MegaCli/MegaCli H This should produce a large help output. For example, for Symbios/LSI/Avago MegaRAIDs and recent Dell PERCs: smartctl -i /dev/sda -d megaraid,0 smartctl 6.6 r4324 x8664-linux-4.15. Check Disk Health Status When Using Hardware RAID. Navigate to the /tmp directory and extract tar archive with the following command: tar -xvzf MegaCliSIEM.tar Type: sh installer.sh You should now be able to use the MegaCli toolset. Subsystem: Super Micro Computer Inc Device 0605įlags: bus master, 66MHz, medium devsel, latency 0, IRQ 53 In general, you smartctl from smartmontools is able to see hard disk info through various hardware RAID controllers.
RAID bus controller: Intel Corporation 82801 SATA RAID Controller (rev0 5)
0 kommentar(er)
